The purpose of this workshop is to provide a forum for FDA, medical device manufactures, additive manufacturing companies, and academia to discuss technical challenges and solutions of 3D printing. The Agency would like input regarding technical assessments that should be considered for additively manufactured devices to provide a transparent evaluation process for future submissions.
- Date, Time and Location
- Federal Register Notice
- Registration
- Contact Us
Date, Time and Location
This meeting will be held October 8-9, 2014, beginning at 8:00 a.m. at the following location:
FDA White Oak Campus
10903 New Hampshire Avenue
Bldg. 31, Room 1503 (the Great Room)
Silver Spring, MD, 20993
- Link for FDA Campus Information
The workshop will also be available via webcast.
Registration to Attend the Workshop
If you wish to attend this Workshop, you must register by close of business on September 30, 2014.Â
There is no fee to register for the Workshop and registration will be on a first-come, first-served basis. Early registration is recommended because seating is limited.
Contact Us
If you require special accommodations due to a disability, or need additional information regarding registration, please contact: Susan Monahan, Office of Communications, Education, and Radiation Programs, Center for Devices and Radiological Health, Food and Drug Administration, 10903 New Hampshire Avenue, Bldg. 66, Silver Spring, MD 20993, 301-796-5661, FAX: 301-847-8142, [email protected].
For questions regarding workshop content please contact: Matthew Di Prima – Office of Science and Engineering Laboratories, Center for Devices and Radiological Health, Food and Drug Administration, 10903 New Hampshire Avenue, Bldg. 62, Silver Spring, MD 20993, 301-796-6300, [email protected].